Torsion : Derivation, assumptions and application
Find a pen or pencil on your table hold one end tightly and rotate with the other end. The pen or pencil in your hand is subjected to torque. This
Kamal Patel
Design of steel beams (Laterally supported)
In this article, you will learn how to design a steel beam. In the previous article, we discussed the different types of sections used as steel beams. We have also
Combined stress: Due to bending and torsion
When you push or pull on something, like a beam or a shaft, it doesn’t just bend or twist—it usually does both at the same time. We call this “combined
Poisson’s ratio | Definition, illustration, and key-points
Poisson’s ratio is a crucial concept for engineers. It helps us understand how materials respond to forces. Think of pressing on something – does it just squish down, or does
How to Design a Beam for Flexure
Welcome to Igen Plus! In this blog post, we’ll walk you through the process of designing a beam for flexure based on the loads calculated in our previous video. If
How to Calculate Load on a Beam: A Step-by-Step Guide
Welcome to EigenPlus! In this blog post, we’ll take you through the process of calculating the load on a beam. We’ll go through each step and discuss what we’ve decided
Simple stress | Definition and application
Stress is required to design the structure. The safety of the structure is assured by this. We will discuss in this blog how we can measure the it in the
Combined shear and bending stress in the beam
We have seen in the previous articles how bending stress comes in the beam and how we can find the shear stress. While deriving the bending and shear stress we
Viscosity | Definition, application and implementation
Take three glasses and fill them with water, oil, and honey. Take the eraser from your table, drop it in the above three different glasses one by one, and note
How do we calculate the stress due to thermal variation?
Structures often experience significant temperature variations during their service life. These temperature changes can lead to the generation of stress within the structures. As engineers, it is our responsibility to